NTN Bearing de Mexico, S.A.

Self Aligning Ball Bearings

Self-aligning ball bearings have two rows of balls, a common sphered raceway in the outer ring and two deep uninterrupted raceway grooves in the inner ring. They are available open or sealed. The bearings are insensitive to angular misalignment of the shaft relative to the housing (fig. 1), which can be caused, for example, by shaft deflection.

This type of ball bearing is recommended when alignment of the shaft and housing is difficult and the shaft may flex. The outer ring has a spherical raceway and its center of curvature coincides with that of the bearing; therefore, the axis of the inner ring, balls and cage can deflect to some extent around the bearing center. Pressed steel cages are usually used. Since the contact angle is small, the axial load capacity is low. The permissible dynamic misalignment is approximately 0.07 to 0.12 radian (4 to 7 degrees) under normal loads.
However, depending on the surrounding structure, such an angle may not be possible.

CONSOLIDATED BEARING 2207 M Self Aligning Ball Bearings
85.0
RBEC 1
CONSOLIDATED BEARING 2207 C/3 Self Aligning Ball Bearings
0.0853
77.00 mm
CONSOLIDATED BEARING 2207 C/2 Self Aligning Ball Bearings
193
105
CONSOLIDATED BEARING 2206-2RS Self Aligning Ball Bearings
HH234048/10
152.4x307.975x88.9
CONSOLIDATED BEARING 2207 Self Aligning Ball Bearings
Round Flange
71040 lbf
CONSOLIDATED BEARING 2206E-2RS Self Aligning Ball Bearings
1120
1120x1460x206
◂ Previous page Next page ▸
All Products Contact Now
Product Categories
Angular Contact Ball Bearings
Cam Follower and Track Roller - Stud Type
Cartridge Unit Bearings
Cylindrical Roller Bearings
Insert Bearings Cylindrical OD
Mounted Units & Inserts
Needle Non Thrust Roller Bearings
Pillow Block Bearings
Precision Ball Bearings
Self Aligning Ball Bearings
Single Row Ball Bearings
Sleeve Bearings
Spherical Plain Bearings - Rod Ends
6306 Bearing
Bearing 6901
L68149 Bearing
Ucp210 Bearing